Filter
Top Products
Before using for the first time
The stainless steel surfaces and trim
are covered in a protective sheeting for
transport.
^
Do not remove the sheeting until the
appliance has been installed in its
final location. To peel the sheeting
off, start at one of the upper corners.
^
Next, coat the stainless steel
surfaces with a special stainless steel
product (which is available through
customer service).
^
Clean the inside of the appliance and
the accessories with warm water and
some mild soap. Dry with a soft cloth.
It is very important to let the
appliance stand for 30 to 60 minutes
after transport before you plug it in
for the first time. Failure to do so can
prevent the appliance from
functioning properly!
Switching the appliance ON
The refigerator and freezer sections
can be switched on separately, so that
you can choose which sections you
want on at a given time.
Refigerator section
^
Press the ON/OFF button for the
refrigerator section.
You will see the temperature display for
the refrigerator section come on. The
refrigerator will now start cooling, and
the interior light will come on when you
open the door.
Freezer section
^
Press the ON/OFF button for the
freezer section.
You will see flashing bars in the
temperature display for the freezer
section, which will now start cooling.
Allow the appliance to run for a few
hours before placing food in it. This will
ensure that the temperature is
sufficiently low.
Cool pack
Place the cool pack in the top drawer of
the freezer section or, to save space,
on the freezer tray (may vary by model).
The cool pack will be at its most
effective after it has been in the freezer
for approximately 24 hours.
Switching the appliance OFF
^
Press each ON/OFF button, so that
the temperature display goes out.
The cooling process is now switched
off. If this does not happen, then the
safety lock is engaged.
Switching the appliance ON and OFF
12