Filter
Top Products
Mount the door handles back into
place.
The following instructions must be
followed when attaching the door
handle, because the door seal could
be damaged otherwise.
^ First, loosely screw the door handle
onto the opposite side, using the two
forward screws b.
The mounting plate c must be
positioned on the door housing in such
a way that when the door is closed, the
mounting plate is aligned with the
outside wall of the appliance. If this
alignment is off, you can correct it by
^
turning both of the pre-mounted set
screws a with a wrench until the
mounting plate c reaches the
correct angle.
^
Tighten all 4 of the screws b.
^
Starting from the appliance side,
slide the sidebar d onto the guide
for the mounting plate, until it auidbly
clicks into place.
You must make sure that the sidebar
d does not come in contact with the
door seal when the door is opened.
This will damage the door seal over
time.
If you see that the sidebar is coming
into contact with the door seal,
^
you must adjust the mounting plate
c again, using the set screws a,
until the mounting plate and the
sidebar d are at the appropriate
angle, and the seal is no longer
touched when the door is opened.
Changing the door hinging
45