Filter
Top Products
Time display
Before the program starts, the display
shows the runtime of the selected
program in hours and minutes. The
remaining runtime is displayed during
the program.
Symbols will appear to indicate the
stage of the program:
1 Pre-wash
8 Main wash
% Interim rinse
( Final rinse
G Drying
O End (Finished)
The runtime that is displayed may vary
for the same program. It depends on
the temperature of the incoming water,
the reactivation cycle and the quantity
of dishes.
When a program is selected for the first
time, the display shows an average
program runtime for warm water.
The runtimes change if the electrical
connection is changed.
Standby
A few minutes after the last button is
pressed or a few minutes after the end
of the program, the commercial
dishwasher will switch into Standby
mode to save energy. The display and
the indicator lights are turned off and
only the Start/Stop indicator light
flashes slowly.
^
Press any button to turn the display
back on.
If the commercial dishwasher is not
turned off after the program ends, after
a few minutes in standby mode it will
turn off completely (see "Settings menu
- Optimizing Standby").
The commercial dishwasher will not
switch to Standby if Refill salt, Rinse
aid or a fault is displayed, or whilst a
program is running.
The refill messages can be turned
off to let the commercial dishwasher
go into Standby mode without first
refilling (see Settings menu - Refill
messages).
However, fault messages cannot be
turned off.
Operating the commercial dishwasher
39