Moyer Diebel 301HT M2 Dishwasher User Manual


 
5
Chemical Dispensers
adapter(suppliedbyothers).Donotconnectdrainhosetoa90°draintting.
Detergent
The machine is equipped with an automatic detergent dispensing pump system.
1. Useaqualieddetergent/chemicalsupplierforyourdetergent.
2. Yourmachineissuppliedwithadetergentdispensingpumpthatisinternallywiredandreadyfor
use.Useacommercialgradeliquiddetergentandinserttheredpickuptubeintothedetergent
container. The pickup tube has a strainer on the end to prevent the crystallized chemical from
clogging the supply lines.
Always wash hands under running water if they come into contact with the detergent and comply
withtheinstructionspertainingtothespecictypeofdetergent.
To prime the peristaltic pump:
1. Insert pick-up tube into the detergent container.
2. Close machine door and switch machine on.
3. Push and hold the prime switch.
Rinse Aid
1. Useaqualied/chemicalsupplierforyourrinseaidneeds.
2. Insert the transparent tube into the container containing the rinsing agent.
3. Push and hold the prime switch
Completing the Installation
1. Remove any foreign materials from inside the machine.
2. Installthescrapscreens,washandrinsearms,strainerbasketandoverowtube.
3. After plumbing and electrical connections are completed, check machine for water leaks by
closing the door, then depressing the ONswitch.Thisallowsthetanktobeginllingandto
reach temperature.
4. Open the door and check the water level. The water level should be 2 inches above the scrap screen.
5. Close the door fully.
ATTENTION:
Chemical dispensers must be electrically grounded in compliance with applicable electric codes.
Caution:
Connecting chemical dispensers at points other than those recommended by the factory
may damage the dishwasher electrical system. Damage caused by the installation of
chemicalequipmentwillnotbecoveredtheWARRANTY.
Installation