Moyer Diebel 301HT M2 Dishwasher User Manual


  Open as PDF
of 50
 
12
Inordertondthecauseofabreakdownorabnormaloperatingconditioninyourdishwasher
please ensure that:
1. All power switches are ON.
2. Drainoverowtubeisinplaceandseated.
3. Wash spray arm nozzles and rinse nozzles are clean.
4. Spray arms are in their proper positions.
5. Pump intake and wash tank screens are clean and properly positioned.
6. Detergentandrinse-aiddispensersareadequatelylled.
7. Door is fully closed.
Refer to the Troubleshooting Guide below before contacting an authorized service agent for repair.
Condition Cause Solution
Cycle keeps running
anddoesnotnish Coldmachine ................ First cycle of the day could take
20 minutes if machine did not warm up.
Machine will not start Main switch disconnected . . . . . . Turn on switch.
Door not closed . . . . . . . . . . . . . .Make sure doors are fully closed.
Door safety switch faulty . . . . . . .Contact your service agency.
Start switch faulty .............Contact your service agency.
Low or no water Main water supply is turned off. . .Turn on house water supply.
Drain/overowtubeisnot
in place and seated . . . . . . . . . . .Placeandseatdrain/overowtube.
Machine doors not fully closed ...Close doors securely.
Faultyllvalve . . . . . . . . . . . . . . . Contact your service agency.
Continuouslling Fillvalvewillnotclose . . . . . . . . . Contact your service agency.
Drain/overowtubenotinplace . . Installdrain/overowtubeintank.
Air trap lost pressure . . . . . . . . . .Drainmachine,reinsertdrain/overow.
andrellmachine.
Motor not running Defective motor . . . . . . . . . . . . . . Contact your service agency.
Wash water temp Incoming water temp low. . . . . . . Raise temperature to 140°F/40°C
to low when in use for 40°F/22°C rise booster heater.
Raise temperature to110°F/39°C
for 70°F/39°C rise booster heater.
Defective thermometer .........Check or replace.
Defective thermostat . . . . . . . . . .Check for proper setting or replace.
Defective heater element .......Check or replace.
Troubleshooting
Troubleshooting
 previous next