EN
NOTE: if you only want to heat the milk and not create froth, ensure that the steam pipe is pushed up to the highest point, so that there is a
gap between the bottom of the steam pipe and nozzle.
READY TO FROTH YOUR MILK
1. Complete previous Steam Out steps. 3. Adjust steam pipe into frothing position, and hold it in
bottom of jug to avoid splashes.
4. Move steam handle to .
7. Proceed to steam out your machine for 5 seconds
minimum to remove any milk residues.
2. Fill milk jug to required amount based on recipe.*
5. Once milk froth has reached desired level or temperature
(about 65° C), it is ready.
6. Move steam handle back to ON position and remove milk
jug immediately from below the steam pipe.
TIPS: for perfect milk froth, use fresh milk at refrigerator temperature (about 4° C). For best results, use a milk jug to froth your milk.
*NOTE: milk jug should be double the volume of recipe quantity desired to enable preparation.
BARISTA: FROTHING YOUR MILK
STEAM OUT
1. Fill water tank with potable water.
4.
Move steam handle to . Run steam through
nozzle for 5 sec. to steam out.
NOTE: when steam handle is set to ON, steamer function will remain in heat up mode. To save energy, when done move handle to OFF.
2. Lift cup support and adjust steam pipe into steam out
position.
3. Set steam handle to ON.
5. Move steam handle back to ON when done.
Middle light blinking: heat up
Middle light steady: ready
CAUTION: steam pipe will be hot during and after usage. Use rubber grip area only to avoid burns.
For best performance and hygienic purposes, a steam out of 5 seconds minimum MUST be done before and after each
usage to avoid milk residues from remaining inside and outside the steam nozzle. (See care and cleaning section).
NOTE: after a period of non use and because of residual water in the machine from previous preparations, steam may
release during the heat up. This may happen and will not cause any damage to your machine.
NOTE: as a safety precaution, the steam function will cut out after 90 seconds. To start again move steam handle to ON, then back to
.
12
13
5927_MAESTRIA_MASTER_2012_v12.indd 14-15 07.02.13 14:55