NXR DRGB4801 Range User Manual


 
23
CARE AND CLEANING
Metal Finishes
Wash with soap and water, glass cleaner, or mild liquid spray.
Plastic Finishes
When control panel trim and end caps are cool, clean with soap and water, rinse and dry.
Use a glass cleaner and soft cloth.
Oven Racks
Clean oven racks with solution of detergent and hot water. To clean heavy soil, use a
scouring pad such as steel wool, with plenty of water.
Oven Frame
Clean with hot water, soap-filled steel wool pads or cleaners. Rinse well with clean water
and dry.
Oven Gasket
Do not clean the gasket. The fiberglass material of the oven door gasket cannot
withstand abrasion.
It is necessary for the gasket to remain intact.
Replacing the Oven Light
Turn off the power at the main power supply.
Remove the lens cover from the housing by pulling straight out.
To prevent electrical shock or personal injury, make sure the oven and light bulb are cool
and power to the oven has been turned off before replacing the light bulb. Make sure
the lens cover is in place when using the oven.
Outer Oven Door
Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse
well. You may also use a glass cleaner to clean the glass on the outside door.
Do not use oven cleaners, cleansing powder or harsh abrasives on the outside of the
door.
Inner Oven Door
Do not allow excess water to run into holes or slots in the door. Any soap left on the
liner causes additional stains when the oven is heated.
Before you call for service, please review the potential problem, possible causes and
remedies shown in the table below.