Filter
Top Products
– 16 –
This chapter explains after the unit has been installed how to conduct comprehensive
operation checks on the hardware of the unit using the limited edition of the editing software
program which is pre-installed in the unit.
Note:
Do not install the editing program until the checks described in this chapter have been
completed. Otherwise, it may no longer be possible to run the limited edition of the
program which was pre-installed.
After the power to the unit has been turned on, wait until the Windows NT startup screen has
appeared without any problem. It is only after this that all the checks described in this
chapter are to be performed. For details on the checks and inspections before this screen
appears, refer to Chapters 1 and 2 of this Manual.
When an external VTR is to be used, connect the external input and output devices to both
the component and composite connectors before starting the checks.
4-1. Checking the uploading operation . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
4-2. Check the editing functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
4-3. Checking the downloading operation . . . . . . . . . . . . . . . . . . . . . . . . . 30
4-1. Checking the uploading operation
Proceed with the checks in this section after the series of checks described in
the previous chapters have been completed with no errors found.
In this section, the limited edition of the pre-installed editing software program
is used to check the uploading operation on the startup screen which appears
after Windows NT log-on.
If errors have been detected in the settings as a result of conducting the
checks, refer to the explanations enclosed within the
¬
marks in the sections
concerned in Appendix C and to the “Troubleshooting” section in the
Operating Instructions. (Refer to pages 20–27 of Operating Instructions)
1. Double-click the Panasonic NLE System icon (shown below) on the
Windows NT startup screen to start the limited edition of the editing
software program.
(Startup may take ten seconds or so.)
Checking operation using the
pre-installation program
Chapter
4