Filter
Top Products
– 41 –
¬
When the SCSI device parameters are wrong
¬
O
Change the parameters.
To change a parameter, press the [
:
] or [
;
] arrow key to highlight the
item to be changed.
Next, press the [Enter] key. A pop-up menu will appear, and the
selectable settings are displayed.
Highlight the item to be selected, and press the [Enter] key to make the
selection.
(2) Checking the SCSI IDs
1. Press the [
:
] or [
;
] arrow key to highlight the SCSI channel to be
checked, and press the [Enter] key to make the selection.
(Press the [Esc] key to return to the previous menu.)
2. The selection screen shown below now appears. Press the [
:
] or [
;
]
arrow key to highlight the [SCSI Disk Utilities] item, and press the [Enter]
key.
(Press the [Esc] key to return to the previous menu.)
3. Check that the screen shown below now appears.
(Press the [Esc] key to return to the previous menu.)
Configure/View Host Adapter Settings
SCSI Disk Utilities
Options
¬
When there are not enough devices
¬
O
Check that the power supply has been connected to the SCSI HDD.
O
Check that the SCSI cable has been connected properly.
O
Check the SCSI ID settings.
SCSI ID #0 : No Device
SCSI ID #1 : IBM DDYS-T18350M
SCSI ID #2 : IBM DDYS-T18350M
SCSI ID #3 : No device
SCSI ID #4 : No device
SCSI ID #5 : No device
SCSI ID #6 : No device
SCSI ID #7 : Adaptec SCSI Card 39160
SCSI ID #8 : No device
SCSI ID #9 : No device
SCSI ID #10 : No device
SCSI ID #11 : No device
SCSI ID #12 : No device
SCSI ID #13 : No device
SCSI ID #14 : No device
SCSI ID #15 : No device
Select SCSI Disk and press <Enter>
The figure on the left
shows the information for
channel A.
With channel B, IBM
DDYS-T18350M is
displayed for #0 as well.