Filter
Top Products
– 22 –
14. The uploaded data can be played by inputting the space key after the clip
registered in the bin has been clicked (selected).
15. Check the clip’s playback images on the monitor (video) for monitoring
the pictures.
16. Playback automatically stops at the end of the selected clips.
To stop playback at any time, input the space key again.
)
Were the clips registered in the bin selected when they were clicked?
)
Was the selected clip played (at
a
1 speed) when the space key was
pressed?
)
Did the selected clip stop playing when the space key was pressed
again?
)
Was the playback AV of the selected clip affected by noise or
disturbances?
All the playback images of the clips are checked on the monitor (video) for
monitoring the pictures.
<Check>
This now completes the check for the uploading operation and the uploaded
data for the internal VTR’s 50M
a
2 speed mode.
To conduct further checks on the uploading for
O
Internal VTR (50Mx1): Internal VTR 50M
a
1 speed,
O
Internal VTR (25Mx4): Internal VTR 25M
a
4 speed and
O
Internal VTR (25Mx1): Internal VTR 25M
a
1 speed,
select “Internal VTR (50Mx1)”, “Internal VTR (25Mx4)” and “Internal VTR
(25Mx1)” as the device displayed on the VTR control panel, and conduct the
same checks described above as for “Internal VTR (50Mx2).”
Even with a system that connects an external VTR or a system which uses a
microphone for uploading, select the name of a device displayed from among
those listed below, and conduct the same checks as the ones conducted so
far. The table below shows the settings for the input/output signals, data
format during uploading and RS-422 port in the limited edition of the editing
software program.
Connect the signal lines and conduct the checks in accordance with these
settings.
Name of device
displayed
Video input Audio input
Data format during
uploading
RS-422
connector
External VTR 1 Composite Analog DVCPRO Port 1
External VTR 2 Component Digital DVCPRO 50 Port 1
External VTR 3 SDI SDI embedded DVCPRO 50 Port 2
Microphone ———
Mic input jack
on system’s
front panel used
——— ———