Filter
Top Products
10
Parts and their function
Pedestal connector panel
CONTROL IN RP connector [RP]
This is the connector for the control of signals of the
camera and pan-tilt head.
It is connected to the TO PAN/TILT HEAD connector on
the AW-RP655 multi-function controller and AW-RP555
multi hybrid control panel.
Use a 10BASE-T (equivalent to UTP category 5) straight
cable for the connecting cable.
COM connector [COM]
This is the connector for the control signals used to
extend the camera’s functions.
VIDEO connector [VIDEO]
This the output connector for the convertible camera’s
video signals.
It is connected to the Y/VIDEO connector on the
AW-RC400 cable compensation unit or monitor, etc.
Use a BNC coaxial cable for the connecting cable.
CABLE COMP OFF/ON switch [CABLE COMP]
When this is set to ON, signals which have been cable
compensated for the equivalent of 1640 ft (500 meters)
are output from the VIDEO connector and the Y, Pr and
Pb connectors.
When this switch is used in conjunction with the
AW-RC400 cable compensation unit, the video cable can
be extended up to a maximum of 3281 ft (1000 meters).
Y connector [Y]
This is the output connector for the camera’s video
signals.
It is connected to the Y/VIDEO connector on the
AW-RC400 cable compensation unit or monitor, etc.
Use a BNC coaxial cable for the connecting cable.
AUX connector [AUX]
This is the output connector for the camera’s video
signals.
It enables the SDI signals, VBS signals, etc. from the
BNC coaxial cable connected to AUX IN to be output.
Provide a BNC coaxial cable as the connecting cable.
No cable compensation is provided for the signals which
are output from this connector.
SDI connector [SDI]
This is the output connector for the camera’s video
signals.
It enables the SDI signals, VBS signals, etc. from the
BNC coaxial cable connected to SDI IN to be output.
Provide a BNC coaxial cable as the connecting cable.
No cable compensation is provided for the signals which
are output from this connector.
G/L IN connector [G/L IN]
This is the genlock signal input connector.
It is connected to the G/L OUT connector on the
AW-RC400 cable compensation unit or other unit.
Use a BNC coaxial cable for the connecting cable.
PROMPTER IN connector [PROMPTER IN]
The video signals for the prompter are input to this
connector.
Use a BNC coaxial cable for the connecting cable.
Pr/C connector [Pr/C]
This is the output connector for the camera’s video
signals.
It is connected to the Pr/C connector on the AW-RC400
cable compensation unit or monitor, etc.
Use a BNC coaxial cable for the connecting cable.
Pb connector [Pb]
This is the output connector for the camera’s video
signals.
It is connected to the Pb connector on the AW-RC400
cable compensation unit or monitor, etc.
Use a BNC coaxial cable for the connecting cable.