Filter
Top Products
11
Installation
For a stand-alone installation
Assembling the pan-tilt head
When assembling the pan-tilt head, use the Allen key (provided) and screwdriver, and secure the head by tightening the screws
firmly. After mounting the pan-tilt head, check there is no play in its installation.
Attaching the camera mounting base
Attach the camera mounting base to the rotary arm using the three mounting screws (M522 mm, with flat washers, spring
washers) provided. The installation direction differs depending on how the base is installed.
Attaching the rotary arm
Attach the rotary arm to the rotary head using the four mounting screws (M522 mm, with flat washers, spring washers)
provided. The installation direction differs depending on how the arm is installed.
Camera mounting base
Rotary arm
Rotary head
For installation on the ceiling
Change the guide pin and screw positions as shown in the figure below on the right, and then attach the camera mounting
base to the rotary arm.
Rotary arm
Camera mounting base
Rotary head
Camera Mounting base
Change the positions
of the guide pins.
Change the positions of the
camera mounting screws.