Filter
Top Products
- 13 -
Multi-Stage (Sequential) Heating
The oven can be programmed with up to 3 different
functions to operate in sequence.These can be
MICROWAVE, CONVECTION or COMBINATION
programs.
For 2 stage programming:
Repeat steps 1-3 on page 12, enter the next heating
program, then press Start Pad.
For 3 stage programming:
Follow 2 stage programming and enter a 3rd heating
program before pressing Start Pad.
Changing the Heating Time
The heating time can be increased or decreased
during cooking by turning Timer Dial.
Oven Lamp
The Oven Lamp switches off when the door is closed.
If you want to check the food, press Lamp Pad, it will
then illuminate for 10 seconds.
The Oven Lamp turns on and illuminates for 1 minute
whenever the door is opened.
Repeat Feature
You can repeat the same heating program if you press
Start Pad within 1 minute of the previous program
finishing.
After 1 minute, if Start Pad is not pressed, the display
returns to “0”, or goes blank, if the oven door is closed.
Stop/Reset Pad
Before heating: One tap clears the display.
During heating: One tap stops the heating cycle and
two taps clears the display.
Note: See page 16 for operation while in Program Lock.
Preheat
For best results in combination mode the oven should
be preheated. (See page 18.)
It is useful to keep the oven condition fixed.
For recalling set temperature see page 11.
PROGRAM
1
2
3
TIME
MICRO
%
PREHEAT
CONV
STAGE
PROGRAM
1
2
3
TIME
MICRO
%
PREHEAT
CONV
STAGE
Start
Lamp
Stop
Reset
/
Preheat
Caution:
The oven does not have a NON-TIP Safety Lock on Wire Rack Shelf.
Please be careful when removing food.
Operating Oven in Combination mode
2 stage programming
3 stage programming