Filter
Top Products
- 9 -
Multi-Stage (Sequential) Heating
The oven can be programmed with up to 3 different
functions to operate in sequence.These can be
MICROWAVE, CONVECTION or COMBINATION
programs. If a required heating time is greater than 15
minutes on 100-60 % power, use 2 stage
programming.
For 2 stage programming:
Repeat steps 1-4 on page 8 before then enter the next
heating program, then press Start Pad.
For 3 stage programming:
Follow 2 stage programming and enter a 3rd heating
program before pressing Start Pad.
Changing the Heating Time
The heating time can be increased or decreased
during cooking by turning Timer Dial.
Oven Lamp
The Oven Lamp switches off when the door is closed.
If you want to check the food, press Lamp Pad, it will
then illuminate for 10 seconds.
The Oven Lamp turns on and illuminates for 1 minute
whenever the door is opened.
Repeat Feature
You can repeat the same heating program if you press
Start Pad within 1 minute of the previous program
finishing.
After 1 minute, if Start Pad is not pressed, the display
returns to “0”, or goes blank if the oven door is closed.
Stop/Reset Pad
Before heating: One tap clears the display.
During heating: One tap stops the heating cycle and
two taps clears the display.
Note: See page 16 for operation while in Program Lock.
PROGRAM
1
2
3
TIME
MICRO
%
PREHEAT
CONV
STAGE
PROGRAM
1
2
3
TIME
MICRO
%
PREHEAT
CONV
STAGE
Start
Lamp
Stop
Reset
/
Operating Oven in Microwave mode
2 stage programming
3 stage programming