Filter
Top Products
PG14D: Floor Model Gas Pasta Cooker INSTALLATION
9
DRAIN VALVE CLOSED
O
N
O
T
L
O
F
F
I
P
ON
O
T
L
OFF
I
P
1.9. INITIAL ADJUSTMENTS
After your appliance has been properly installed as described in the installation section of this
manual, it will need to be adjusted to ensure that it will perform as designed. A qualified person must
perform these adjustments.
To perform these adjustments the following tools will be needed:
• Manometer • Digital Thermometer (Temperature Probe) • DC Voltmeter
1.9.1. FILLING THE APPLIANCE
Refer to the following procedure to fill the cook tank prior to
operation.
1. Ensure that the drain valve is closed.
2. Fill the tank with water until the water reaches the water level
line(s).
1.9.2. LIGHTING INSTRUCTIONS
Refer to the following instructions to light the appliance.
1. Open gas supply valves to the appliance.
2. Make sure that the appliance is turned OFF.
3. Turn the gas valve knob to the PILOT position and push in on the knob.
Hold the knob in for approximately one minute to purge the air out of the
line. Hold a flame to the pilot until the pilot ignites; this may take a little
while the first time you light the pilot because of the air in the lines. Once
lit, hold the knob in for approximately one minute and then release.
4. If the pilot goes out, wait 5 minutes and repeat step C. If after three tries the pilot will
not remain lit, refer to the operator troubleshooting section of this manual.
5. Once a pilot flame has been established, turn the gas valve knob
counterclockwise to the ON position.
6. The main burners will light and be controlled by the thermostat.
WARNING
Water must completely cover the heat tubes at all times while appliance is on.
CAUTION
This appliance is not designed for cooking with oil. Fill with potable water only.
WARNING
During operation there is an open flame inside this appliance. The unit may get hot enough to
set near by materials on fire. Keep the area around the appliance free from combustibles.
WARNING
If pilot extinguishes, wait 5 minutes before attempting
to relight the pilot to allow any built up gas to dissipate.