Rangemaster RDW6012FI Dishwasher User Manual


 
3
Salt
The hardness of water varies from place to place. If hard water
is used in the dishwasher, deposits will form on the dishes
and utensils.
The appliance is equipped with a special softener that uses a
salt specifically designed to eliminate lime and minerals from
the water.
Loading the salt into the container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and
should be filled as follows:
1. When the low salt indicator (Fig.2-3) lights, you must fill
the salt. Remove the lower rack and then unscrew and
remove the cap from the salt container.
Note: If you are filling the container for the first time, fill it
with water
2. Place the end of the funnel (supplied) into the hole
and introduce about 2 kg of salt. It is normal for a small
amount of water to come out of the salt container.
3. Carefully screw the cap back on.
IMPORTANT: To prevent the formation of rust, load the salt
just before beginning a wash cycle.
Adjusting salt consumption
The dishwasher is designed to allow for adjusting the amount
of salt consumed based on the hardness of the water used.
This is intended to optimize and customize the level of salt
consumption so that it remains at a minimum.
To adjust salt consumption:
1. Unscrew the cap from the salt container.
2. There is a ring on the container with an arrow on it
(Fig.2-4).
3. If necessary, rotate the ring in an anticlockwise direction
from the ‘–‘ setting towards the ‘+’ sign, based on the
hardness of the water being used.
It is recommended that adjustments be made in accordance
with Table 2-1.
ArtNo.800-0203 -
Low salt indicator
ArtNo.800-0204 -
Adjusting the salt
Water Hardness
Level
Clarke
degrees
°dH mmol/l
Selector
position
Salt
consumption
cycle
Autonomy
(cycles/
2kg)
1 0 - 14 0 -17 0 - 1.7 0
2 14 -36 18 - 44 1.8 - 4.4 20 60
3 36 -71 45 - 89 4.5 - 8.9 MED 40 40
4 > 71 > 89 > 8.9 + 60 25
Table 2-1
Fig.2-3
Fig.2-4