Filter
Top Products
U108910 18
INSTALLATION
Check the appliance is electrically safe when you have finished.
resistant. Certain types of vinyl or laminate kitchen
furniture are particularly prone to heat damage and
discolouration. We cannot accept responsibility for
damage caused by normal use of the appliance
to any material that de-laminates or discolours
at temperatures less than 65°C above room
temperature.
A clearance of 130mm is required if the appliance is built
near a corner of the kitchen to allow the oven doors
to open. The actual opening of the doors is slightly
less but this allows for some protection of your hand
as you open the door.
Unpacking the Appliance
Do not remove any packaging from the appliance until
it is directly in front of the place it is to be installed
(unless it will not fit through a door in its outer
packaging).
Cut the banding straps and lift the cardboard box
off, leaving the appliance standing on the base
packaging. See the loose unpacking sheet.
Moving the Appliance
( WARNING WHEN THE APPLIANCE IS REMOVED
FROM THE PACK IT IS FRONT HEAVY AND CAN
TIP FORWARDS IF DOORS ARE OPENED ETC. DO
NOT REMOVE THE FRONT ROLLER UNTIL THE
APPLIANCE IS SECURELY FIXED IN POSITION.)
The appliance is heavy. Take great care.
We recommend two people manoeuvre the appliance.
Ensure that the floor covering is firmly fixed, or
removed to prevent it being disturbed when moving
the appliance around. You will need the levelling
tool. From the back tilt the appliance forward and
remove the rear half of the polystyrene base pack.
Repeat from the front and remove the front half of the
poly base. Pull the drawer out to its furthest point.
Lift up the ends of the plastic clips (one each side) to
release the catches holding the drawer to the
side runners and at the same time pull the drawer
forward and away from the side runners. For safety’s
sake push the drawer runners back out of the way.
Put the drawer somewhere safe - do not refit it until
the installation is complete.
Lower the Rollers.
Fit the Allen key tool to the centre roller lowering
mechanism (C in the fig. below).