Filter
Top Products
32
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Remove the FSD probe from the probe bracket. Pull
probe clear from the bracket. From the rear of cooker
carefully withdraw capillary. Disconnect the tubes from
the FSD inlet and outlet. Remove FSD adaptor locknut
and remove assembly from bracket. Fit new assembly
and secure to bracket with FSD adaptor locknut.
Ensure that the capillary passes through clearance
hole in the backsheet. Fit probe into bracket by
inserting end into bracket hole. Locating small ferule
in spring clip by positioning it below the clip and lifting
upwards at the same time as prising the spring clip
open until it clips into position.
Replace leads (refer to wiring diagram). Replace wires
in cable ties. Check appliance is gas sound. Refit cover
box. Check for correct operation of solenoid/FSD.
20. To Change Oven Electrode
Remove oven burner (see 16). Remove screw and nut
securing the electrode to the burner. Pull lead from
back of electrode and fit to new electrode. Fit new
electrode to burner.
Reassemble in reverse order. Check ignition.
21. To Remove Grill Door
Remove L H side panel (see 3). Remove the plinth
(4 screws) and the central vertical cover (5 screws).
Remove the two countersunk screws (1 each side)
securing the grill hinge arms to the front of the grill
chamber.
NOTE: The arms are spring tensioned. Carefully
remove the grill door. Retain the gaskets.
Reassemble in reverse order ensuring that the gasket
is fitted between the hinge arm and the front of the grill
chamber.
22. To Change Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fixing screws from both sides of the outer panel (A).
Carefully lift off the outer panel.
Remove the door handle from the panel by unscrewing
the 2 retaining nuts.
Fit the door handle to the new panel. Fit the new panel to
the door. Then reassemble in reverse order.
23. To Change Oven Door Latch
Remove outer door panel (see 22). Remove screws
‘B’ holding latch assembly to inner door panel. Fit new
catch and reassemble in reverse order.
Check correct door operation.
24. To Adjust an Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep,
and screw in or out as required until required fit is
obtained. Retighten locking nut.