Roper MN11020(344197) Oven User Manual


 
Before Calling for Service
r
DON’T CALL FOR SERVICE
UNTIL YOU CHECK
I
PROBLEM
l
Foods do not broil
properly.
!
l
Oven smokes,
l
Oven light or work
light does not work
(if equipped).
- Oven does not clean
or poor cleaning
results (Self-clean
models only).
l
Oven door will not
unlock (Self-clean
models only).
0 Tone does not sound
POSSIBLE CAUSE
.
Improper rack position
l
Oven preheated
. Improper utensil used
. Improper broiling time
l
Dirty oven
l
Broiler pan full of grease left in
oven
9 Light switch in off position
. Light bulb or fluorescent light
starter burned out
9 Controls not set properly
. Clean cycle interrupted too
soon
l
Oven too dirty
l
Clean cycle not complete
. Tone has been eliminated by
pushing and holding CANCEL
button
ADJUSTING OVEN TEMPERATURE
The temperature in your new oven has been set correctly
at the factory, so be sure to follow the recipe temperatures
and times the first few times you bake in your new oven.
If you think the oven should be hotter or cooler, you can
adjust it yourself. To decide how much to change the
temperature, set the oven temperature 25°F higher or
lower than the temperature in your recipe, then bake. The
results of this “test” should give you an idea of how much
the temperature should be changed.
To Adjust Oven Temperature:
1. Push the BAKE button.
2. Select a temperature between 500°F and
550’F with the SET knob.
. Check broil pan placement; see Broiling
section.
. Do not preheat when broiling.
. Use broiler pan and grid supplied with range.
* Check broiling chart.
9 Check for heavy spillover.
. Clean pan and grid after each use
l
Check switch setting.
l
Check or replace light bulb or fluorescent
light starter; see use and care instructions.
l
Check self-clean instructions.
n
Heavrly soiled ovens require a 3 l/2 hr. clean
cycle.
l
Heavy spillovers should be removed before
setting clean cycle.
l
Oven must cool below lock temperature
(20 to 30 minutes after clean cycle is
complete).
. Push and hold CANCEL button to activate
tone.
3. Quickly (within two seconds, before the BAKE Function
energizes) push and hold the BAKE button.
The display will change to the amount of degrees
difference between the original factory temperature
setting and the current temperature setting. If the oven
has the original factory setting, the display will read 00.
4. The temperature can be adjusted up to 35°F hotter or
cooler (in 5°F steps), by turning the SET knob. A
minus sign (-) before the number means that the oven
will be cooler by displayed amount of degrees.
5. When you have made the desired adjustment, push
the CLOCK button to go back to the time of day display
or use your oven as you would normally.
Note: The self-clean temperature will not be changed by
the adjustments described above.
22
GSER27