Filter
Top Products
INSTALLATION
INSTALLER: Leave these instructions with the
OWNER: Keep these
appliance.
use.
nstructions for future
TOOL LIST
1. 18” drill brt
2. Electric or hand drill
3. Flat bladed screwdriver
4. No 1 or No. 2 Phillips screwdriver
5. Pencil
6. Ruler and straight edge
7. Hand saw or saber saw
8. Pipe wrench
9. 5’8” wrench and 112” wrench or adjustable wrench
10. :3116” hex socket driver
LOCATION
C,~brie’ sp,ice must be provided to completely enclose the
recessed pan of your built-in oven except for the vent thimble
on outside vented units See Figure 1 for all necessary
dime-IsIons A cutout 22” wide by 38” high must be made in
the cabnet front. It
IS
best to make a template to insure
accurate cutting
Place the bottom of the template on a level base line, 22 ‘to
28” abc$Je lhe floor This :vIII posrtion the open oven 36” to
42 abc~ve the floor
-J
If you are replacing an older oven that had a cutout height of
more than 38”, see page 6.
It is important that the oven be installed at cr above the
minimum height specified. The unit has been tested and
approved, in accordance with safety standards, at this
height. The vent area may get hot when the oven is in
use. Following these installation instructions will move the
vent area out of a ran!; where it would likely be touched by
small children.
The cabinet must have a solid bottom. The solid bottom may
either be at the floor or level with the bottom edge of the
cutout opening. If the solid bottom is to be at the floor, two
runners, centered within the cabinet, 1l”apart may be used
to support the oven.
Be sure the oven support is solid enough to hold the weight
of the unit - about 130 pounds. Also, be sure the oven
support is level and straight.
Drafts inside the oven cabinet may affect safe use of your
oven. Any openings around gas and electric service outlets
must be sealed at the time of installation to prevent drafts.
r
\ j
-_-_-----
OVEN
3 0,’
M I N
I
WALL OR
/
CABINET
Fig. 1
* Should be adjusted to suit both standard cabinetry and
desired oven working height
GlNS56-1