Filter
Top Products
setting up _11
01 SETTING UP
setting up your side-by-side
refrigerator
SETTING UP THE REFRIGERATOR DOORS
If your entrance won’t allow the refrigerator to pass easily through it, you can remove the doors.
Removing the Front Leg Cover
First, open both the freezer and refrigerator doors, and then take off the front leg cover by
turning the three screws counter-clockwise.
Separating the Water Supply Line from the Refrigerator
1. Remove two water lines(gray one is for ice and the other one is for water)by pressing the
coupler
1
and pulling the water line
2
away.
:
Reattaching the Water Supply Line
1. Water line must be fully inserted to the marked line to prevent water leakage and water
dripping of water dispenser.
2. Insert the 4 clips in the install pack and check that each clip holds the line firmly.
Do not cut the water line. Gently separate it from the coupler.
Line
Line
Coupler Coupler
Coupler
clip A
(6.35mm)
clip B
(8mm)
clip A
(6.35mm)
clip A
(6.35mm)
1
2
Be careful that the
water tube match same
color.
DA99-01745A(EN)-GGH-0.3.indd 11 2008.8.20 8:41:53 PM