Filter
Top Products
16_ setting up
CHECKING THE WATER DISPENSER LINE
A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote
better health, the Samsung water filter removes unwanted particles from your water. However, it does not
sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that.
In order for the icemaker to operate properly, water pressure of 138 ~862 kPa is required. Under normal
conditions, a 170 cc paper cup can be filled in 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a booster
pump to compensate for the low pressure.
Make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water
dispenser lever until the water runs from the water outlet.
Water Line installation Kits are included with unit. You can find it in freezer(or fridge) drawer.
Parts for water line Installation
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water Line Installation Instructions
in the installation kit.
4. After connecting the water supply to the water filter, turn your main water supply
back on and Dispense about 3L to clear and prime the water filter.
Close Main
Water pipe
Close Main
Water pipe
No gap
1
Water line fixer
and screws
2
Pipe connector
3
Water line
5
Water Filter
CAUTION
The water line must be connected
to the cold water pipe.
If it is connected to the hot
water pipe, it may cause the
purifier to malfunction.
4
Clip
DA99-01745A(EN)-GGH-0.3.indd 16 2008.8.20 8:42:1 PM