Filter
Top Products
setting up _17
1
2 3
Sticker
(month indicator)
1
01 SETTING UP
setting up your side-by-side
refrigerator
INSTALLING THE WATER DISPENSER LINE
Connecting the water line to the refrigerator
1. Remove the cap from water line on the unit and insert compression nut to the water line on
the unit after disassembling from provided water line.
2. Connect both water line from the unit and water line in the kit
3.
Tighten the compression nut onto the compression fitting. Be careful no gap between two items.
4. Turn water on and check for any leakage.
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to
make sure you get a snug, leak-free connection.
Before being used, the leakage in these places should be examined
• Samsung Warranty does not cover WATER LINE INSTALLATION.
• It’ll be done at customer’s
charge unless the retail price
includes installation cost.
• Please contact Plumber or
Authorized Installer for the
installation if needed.
• If Water leakage occurs due to
improper installation, Please contact installer.
Installing the water filter.
Before installing the water filter, please
remove the top shelf.
1. Remove the water filter cover(
1
)
2. Remove the fixed cap by turning it counter
clockwise. Keep the cap in a safe place for later
use if you don’t use a filter.
3. Remove the water filter from the box and put
a replacement indicator sticker on the filter as
shown. Place a sticker on the filter that dates
six months in the future. For example, if you
install the water filter in March, put the “SEP”
sticker on the filter to remind you to replace in
September. That way you’ll know when it is
time to replace the filter. Normally, a filter life is
about 6 months.
Remove
cap
Water Line
from unit
Water Line
from Kit
No gap
Loosen a
CAUTION
DA99-01745A(EN)-GGH-0.3.indd 17 2008.8.20 8:42:3 PM