Filter
Top Products
2
2 - 32
10. Compressor
W-2WAY ECO-i SYSTEM
Outdoor Unit Repair Procedures
(1)
(2)
*
(3)
(4)
(5) Temporary mount 2 cushion rubbers with bolts at the position as shown in the figure 27.
Set up the leg of the new compressor onto the 2 cushion rubbers.
Fig. 26
O-ring
Fixing nut
at the main unit side
Fig. 27
Front view
Cushion rubbers
Bolts
(Temporary mounting: 2 locations
at back side, each 1 piece)
Remove the 2 brazed tube caps (2 pieces) from the compressor.
Remove hexagonal caps from the compressor.
When removing the hexagonal caps, hold the fixing nut at the main unit side so as not to loose it with a
wrench or spanner. And then, loosen and remove the hexagonal cap.
Remove the oil equalizer tube connector parts along with the O-ring from the removed compressor and
mount them on the replaced new compressor.
Install the crankcase heater onto the new compressor.
Hexagonal cap
Oil equalizer tube
connector parts
Installation