Filter
Top Products
64
31
TEMPERATURE RECORDER (OPTION)
Installation of MTR-85H
1. Remove 4 screws (A, B, C, D) on the side of the
front panel to take off the front panel. Then remove 4
screws on the cover for the recorder mounting space
and take off the cover (Fig. 1). After removing the
cover, replace 4 screws.
2. As shown in Fig. 2, install the recorder to the front
panel by using the fixture enclosed with the recorder
and the mounting plate (MDF-S3085).
3. Lead the recorder sensor to the chamber through
the access port at the bottom of the chamber.
Note:
The port is covered with a thermal insulation and
rubber cap. Remove those covers before passing
the recorder sensor.
4. Fix the recorder sensor to the inside of the sensor
cover (MTR-C8) by using the enclosed clips and
screws and seal the access port on the chamber side
with a silicon. (Fig. 3)
Front panel
A
B
C
D
Cover
Fig. 1
Mounting plate
Fixture
Recorder
Fig. 2
Recorder sensor
Silicon
Sensor cover
Fig. 3