Filter
Top Products
REMOVABLE OVEN DOOR
To remove:
1. Open the doer to the stop position {see illustration).
2. Grasp the door at each side and lift up and off the hinges.
NOTE: When the door is removed and hinge arms are at
stop position, do not bump or try to move the hinge arms.
The hinges could snap back causing an injury to the
hands or damage to the porcelain on the front of the
range. Cover the hinges with toweling or empty towel
rolls while working in the oven area,
To replace:
1. Hold the door over the hinges with the slots at the bottom
edge of the door lined upwith the hinges. The hinge arms
must still be in the stop position.
2. Slide the door down onto the hinges as tar as itwill go and
close the door.
STOP (BROIL) POSITION
HINGE
/
REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when installing
or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pair of rack
guides.
2. Push the rack in until you reach the bump in the rack
guide, then lift the frontof the rack a bit and push the rack
all the way in.
TOremove:
1. Pull the oven rack out, then up.
Some models have one standard oven rack and one folding
oven rack.
The folding rack can be conveniently stored away when not
in use.
REMOVABLE OVEN BOTTOM
The oven bottom may be removed for cleaning heavy spill-
overs or to reach the oven burner.
Becareful not to scratch the oven finish when removing
or replacing the oven bottom.
To remove:
1. Slide the tab at the center front of the oven bottom to the
left.
2. Lift the oven bottom up and out.
To replace:
1. Slip the oven bottom into the oven so the tabs in the rear
of the oven bottom fit into the slots in the oven back.
2. Lower the tront ofthe oven bottom into place and slide the
tab at the front right to lock the oven bottom into place.
24 GMNT06 1