Filter
Top Products
52
Using the components
Switching the components on/off
Switching the transmitter on/off
̈ Press the ON button ᕦ to switch the transmitter on.
̈ To switch the transmitter off, press the ON button until “OFF” appears on
the display.
Note:
The transmitter can only be switched off when the standard display is
shown on the display panel. Within the operating menu, the ON button
serves as the ESC (cancel) key, i.e you cancel your entry and return to the
standard display.
Switching the receiver on/off
̈ To switch the receiver on, turn the volume control Ƹ clockwise until it
clicks. The red LED ᕣ lights up.
̈ To switch the receiver off, turn the volume control Ƹ counterclockwise
until it clicks. The red LED ᕣ goes off.
Note:
y The receiver has a short switch-on delay.
y Remove the batteries or the accupack when the receiver will not be used
for extended periods of time.
Adjusting the volume
You can adjust the volume at the headphone output on both the transmitter
and the receiver.
̈ Use the volume control ᕢ or Ƹ to adjust the volume of the connected
headphones.
Volume up? – NO!
When people use headphones, they tend to choose a higher volume than
with loudspeakers. Listening at high volume levels for long periods can
lead to permanent hearing defects. Please protect your hearing,
Sennheiser headphones have an excellent sound quality even at low
volumes.
ᕦ
»
Ƹ
Ƹ
³ ·