Filter
Top Products
66
a button, the display jumps either forwards or backwards to the next
character. If you hold down a button, the display starts cycling
continuously.
̈ Press the SET button to change to the next segment and select the next
character.
̈ Have you entered the name completely? Press the SET button to store
your setting and to return to the previous menu level.
Loading the factory-preset default settings
RESET
Reset
Via the “Reset” menu, you can load the factory-preset default settings. With
the receiver, however, the selected setting for the pilot tone remains
unchanged. After the reset, the unit is restarted and the standard display is
shown on the display panel.
Activating/deactivating the pilot tone evaluation
(receiver only)
PILOT
Pilot
Via the “Pilot” menu, you can activate or deactivate the pilot tone evaluation
of the receiver. The pilot tone is used
y to code the transmitter’s stereo signal,
y to support the squelch function (Squelch).
During stereo operation, the transmitter adds the pilot tone to the
transmitted stereo signal and the receiver detects and evaluates the pilot
tone. When the transmitter is set to mono operation, deactivate the pilot
tone evaluation on the receiver.
You can combine units of first and second generation ew 300 IEM systems
without any problems.
Adjusting the contrast of the graphic display (transmitter
only)
LCD-Contr
Via the “LCD Contr” menu, you can adjust the contrast of the graphic display
in 16 steps.
Stereo/Mono selection (transmitter only)
Mode
Via the “Mode” menu, you can switch the transmitter between mono and
stereo operation.
Note:
Connect any unit that only delivers a mono signal to the transmitter’s left
XLR-3F socket ᕩ and set the transmitter to mono operation. The receiver
automatically “identifies” the transmitted audio signal and does not need
to be set to mono operation. However, you have to deactivate the pilot
tone evaluation on the receiver.
¾