Filter
Top Products
14
System settings
■ Clear Address Book and Registered Data
This function is used to clear the items indicated below, which cannot be cleared or
initialized using "Clear All Memory" (page 11 of this manual) or "Restore Factory
Defaults" (
➞
System Settings (Administrator) > "Storing/Calling of System Settings" >
"Restore Factory Defaults").
● User Information
● Individual/Group/Program/Relay Broadcast Memory Box
● Polling Memory/Confidential Memory Box
*2
●
Sender Data
● Allow/Reject Reception Setting Data (including polling passcode number)
*1,*3
●
Forward Information
*4
*1
The name may vary depending on the options that are installed.
*2
Can only be selected when the fax function is enabled.
*3
Can be selected when either the fax function or the Internet fax function is in use.
("including polling passcode number" is displayed only when the fax function is
enabled.)
*4
Select this when you only wish to erase stored forwarding information.
Step 1: Select the checkbox of each item that you wish to clear.
Step 2: Touch the [Clear] key.
A confirmation message prompting you to select "Yes" or "No" will appear.
Step 3: Touch the [Yes] key.
The selected data is cleared.
(Operation during clearing is the same as "Clear All Memory" (page 11 of this manual).
However, it is not possible to cancel during clearing.)
Select the data to be cleared and press [Clear].
BackClear
System Settings
Clear Address Book and Registered Data
Individual/Group/Program/Relay Broadcast Memory Box
User Information
Sender Data
Polling Memory/Confidential Memory Box
Forward Information
Allow/Reject Reception Setting Data(Including polling passcode number)