Filter
Top Products
54
Instructions for the user
Make sure you only use containers intended for induction cooking, with a
thick and completely flat bottom, or, if not available, containers without
a curved bottom (concave or convex).
YES NO NO
6.7.5 Cookware detector signal
Every cooking zone has a “cookware detector” that only starts the cooking
if there is a well positioned container with the suitable characteristics
present on the burner.
If the container is not well positioned or is not made of the correct material
and still tries to activate the burner, after a few seconds from the burner's
activation, the symbol will appear on the display.
6.7.6 Residual heat
Each cooking zone is equipped with a residual heat warning device. After
any zone is switched off, a flashing “ ”may appear on the display. This
warns that the cooking zone concerned is still very hot. Cooking can be
restarted while the " " is flashing: in this case, proceed as described in
point “3”.
6.7.7 Cooking hob lock-out
When not in use, the hob can be “locked” from being accidently turned on
by children.
With the hotplates switched off, turn the control knobs to the left at the
same time until the power display shows the letter “L”, then release the
knobs. To unlock it repeat the same operation: The burners' displays will
show a 0 that will indicate that the burners' lock has been deactivated.
6.7.8 Circuit board thermal protection
The appliance is provided with a device that constantly measures the
temperature of the electronic circuit board.
If the temperature surpasses certain values, the device will activate certain
functions to lower the temperature and allow the glass ceramic hob to
continue to work correctly.
Below is a table with the operations that are activated automatically and
the relative start temperature: