Filter
Top Products
61
Instructions for the installer
8.1.2 Fixing to the electric model support structure
Create an opening in the counter top with the dimensions shown in the
figure, keeping a minimum distance of 40 mm from the rear edge. The
lower part of the casing must be fully accessible after the appliance has
been installed.
This appliance can be mounted against walls
higher than the work surface on condition that a
distance of “X” be kept between the appliance and
the wall as shown in the figure so as to avoid
damage from overheating. Make sure that there is
a minimum of 750 mm (Fig. 1) between the hob
and any shelf that may be installed directly above
it.
WARNING: IF YOU ARE INSTALLING A HOB FITTED WITH FISH
BURNER, THE DISTANCE "X" FROM THE SIDE WALL, EXTENDS
FROM 100 mm TO 300 mm.
Furthermore, this kind of appliance
needs a milling on the hob top of 3 mm
in depth; the measurements are
indicated in figure 2 (detail A). Before
positioning the hob, the supplied
adhesive sponge “E” must be spread out
over the entire surface of the milling (fig.
2). After carrying out these operations,
use the 7 brackets provided to fit the hob
to the structure. The figures below show
how to use these brackets.
We would advise the right section for
laminated tops with a thickness
less than 3 mm