Filter
Top Products
User instructions
29
If the water hardness has been set on a value above H3, and the 3/1
option is activated, the DISPLAY (G) flashes, warning of a setting error,
because these products are not suitable for use with very hard water.
This does not prevent the use of the option, but the washing results
might not be of the best.
EXTRA SANITISATION RINSE (depending on model)
Shown on the DISPLAY (G): "Extra hygiene 1/0".
Press (D) to display the option and press (E) to enable (1 on display) or
disable (0 on display) it.
This function performs an extra sanitising rinse at the end of the washing
cycle, assuring a further reduction in the number of bacteria present.
If the temperature falls while the sanitisation rinse is in progress (e.g.
due to a power blackout or because the door is opened), the DISPLAY
(G) flashes until the dishwasher is switched off or a new program is set,
to warn that the option has not been carried out.
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
x Always try to run the dishwasher fully loaded.
x Do not wash the dishes in running water.
x Use the washing program that is most appropriate for each type of
load.
x Do not carry out any preliminary rinsing.
x If available, connect the dishwasher to a hot water supply up to
60°C.
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT
THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the
environment. To avoid using excessive amounts of detergent and to
save on electricity, observe the following:
x separate the more delicate items from dishes that are more
resistant to aggressive detergents and high temperatures;
x do not pour the detergent directly on the dishes.