Filter
Top Products
User instructions
25
CONTENTS OF DISPLAY WHEN PROGRAM IS IN PROGRESS
The top line displays the temperature in the tank, alternating (every 4
seconds) with the program being performed and the current program
stage.
The bottom line will show the program duration "Duration XX min",
where XX is the time left before the end of the program, in minutes.
If DELAYED START (C) is set, until the program starts the second line
shows the message "Starting in YY hh/mm", where YY are the hours
(from 1-12/1-24 depending on model) or minutes (when less than 1 hour)
left before the program starts.
Any warning messages (e.g. "No salt") will appear on the DISPLAY (G)
during the washing stage, alternating with the time left to the end of the
program.
If the 3/1 PRODUCTS function (only available on some models) is set,
the no salt and no rinse aid warning messages do not appear.
INTERRUPTING A PROGRAM
To interrupt a program, press the START/PAUSE key (F) and keep it
pressed until "In pause" appears on the bottom line of the DISPLAY (G).
To restart the program, repeat this operation until "Duration XX min"
reappears on the bottom line of the display.
Opening the door only cuts out the program in progress, but this is not
recommended, since water splashes or gusts of steam might escape.
When the door is closed the program restarts automatically, even it
was interrupted by pressing the START/PAUSE key (F).