Filter
Top Products
User instructions
26
CHANGING THE PROGRAM
To change a program while it is running, proceed as follows:
x press key (F) to set the program in pause status;
x open the door and select the new program using key (B);
x close the door; the changes relating to the new program will
appear on the DISPLAY (G).
ANNULLING A PROGRAM
x To annul a program while it is running, it must first be interrupted by
pressing key (F);
x then open the door and press key (B) in repetition until you obtain
"Cancel program";
x close the door. "Draining" will appear on the DISPLAY (G) and the
dishwasher will start to pump out the water. This will be completed
in about 1 minute and "Program end" will appear on the top line of
the display.
Before the door is closed, a long washing time will appear alongside
"Draining". This is not a malfunction but simply a stage in the time
update process; the time will be corrected to 1 minute when the door is
closed.
END OF PROGRAM
At the end of the program the buzzer sounds (if enabled), after which the
temperature and program name will alternate with "Program end" on the
top line of the DISPLAY (G); the bottom line continues to show
"Duration XX min".