Filter
Top Products
User instructions
33
FAULT - DESCRIPTION
Flow meter k.o. (for the relevant models only)
The appliance is not able to "measure" the amount of water loaded accurately. The alarm
is displayed at the end of the cycle, which however is completed since the problem
does not interfere with operation of the dishwasher. If the problem persists, contact
the after-sales service.
Zone washing k.o. (for the relevant models only)
Interrupt the program and switch off the dishwasher. Switch the dishwasher back on,
program it again and start the washing cycle. If the problem persists, contact the after-
sales service.
Press. switch k.o.
Contact the after-sales service.
x "Fault waterblock", "Safety level on", "Heating k.o.", "Temper.
feeler k.o.", "Zone washing k.o." and "Press. switch k.o." trigger
an immediate termination of the program in progress.
x "Watertap closed" and "Drain obstructed" interrupt the program in
progress and then continue it as soon as the cause of the problem
has been dealt with.
To “reset” an alarm is necessary:
x Open and close the door, or turn off and on the machine. At this
point is possible to program the dishwasher again.
If the fault persists, call the authorised Technical Service Centre.