Filter
Top Products
INSTALLATION 500 SERIES RESTAURANT RANGES
PAGE 16 OF 44 OWNER’S MANUAL 1188716 (02/07)
10. Using the cable clamp (item “D”), adjust the restraining device extended length to prevent over-bending or
kinking of the appliance connector.
Figure 6
Installation of Restraint
H
F
I
G
E
D
A
B
C
Be sure all controls are turned off prior to disconnecting. After reconnecting, be sure all controls are turned off and all
pilots are lit.
NOTICE
Adequate means must be provided to limit the movement of the appliance without depending on the connector
and the quick-disconnect device or its associated piping to limit the appliance movement.
The restraining means should be attached to a frame member on the back of the range.