Filter
Top Products
21
SECTION 5
REPLACEMENT PARTS
5.1 HOW TO ORDER PARTS
To assure receipt of the proper replacement parts, supply
your dealer or distributor with the following information:
A. Model number of equipment.
B. Serial number of model, stamped on nameplate.
Part Number Description
324014 Decal Black Arrow
324141 Decal Caution Rotating Blades
324509 Decal Cleaning
324548 Decal Ventilation
324346 Decal Caution
324393 Decal – Drip Tray
324803 Decal – Header Panel (Stoelting Logo)
324804 Decal - Header Panel (Stoelting Swirl)
324806 Decal - Header Panel (A & W Logo)
324798 Decal – CLEAN/OFF/SERVE
324125 Decal – Elec. Shock Hazard
C. Part number, part name and quantity needed.
Common part names and numbers are listed in this
manual.
5.2 PUSH TO FREEZE LIGHT/SWITCH
LAMP REPLACEMENT
To change a lamp in the PUSH TO FREEZE switch/light
follow these simple steps:
A. Grasp the lens with your thumb and forefinger and
pull out.
B. Remove the faulty lamp by pulling out the lamp puller
(See Fig. 33).
Figure 33. Push To Freeze Light/Switch Assembly
C. To install the new lamp, line up the lamp end with the
receptacle and push fully in.
D. Reinstall the lens by pushing firmly in. When installed
“PUSH TO” might be right side up.
NOTE
LED light bulbs require correct polarity. If the bulb
does not illuminate, remove the bulb, turn 180°
and replace.
5.3 CLEAN-OFF-SERVE ROCKER
SWITCH REPLACEMENT
A. Remove side panel.
W ARNING
DISCONNECT FREEZER FROM ELECTRICAL
SUPPLY SOURCE BEFORE SERVICING.