Filter
Top Products
Drawer Panel Installation
MODEL 427RG
IMPORTANT NOTE:
Drawer panels for model 427RG must
be a minimum of
5
/8" (16) thick and cannot exceed 12 lbs
(5 kg) for each panel.
Remove the mounting hardware provided and set aside.
As with the door panel, you should work on the back side
of each drawer panel to protect the front surface.
Position the top edge of the template flush with the top
edge of each drawer. For the top drawer, there is only one
location for the lower mounting bracket. The bottom
drawer allows a second option by inverting the lower
mounting bracket, depending on the height and thickness
of the panel. Refer to the illustration below.
Secure the template in place and mark the pilot holes.
Remove the template and drill pilot holes for mounting the
bracket. Place the mounting brackets in the proper
location with the tabbed bracket on top and L-bracket on
the bottom of the panel. Fasten brackets securely with the
#8 x
1
/2" screws provided. Refer to the illustration below.
Models 427G and 427RG Installation 28
T
o help with proper placement of drawer panels, examine
the lower panel mounting bracket and determine which
slotted holes to use. Position screws into the lower portion
of the drawer that correspond with these slotted holes.
Leave these screws out a small distance so they can help
when you mount the drawer panels to the drawer.
With the two mounting brackets in place, install the
drawer panel by engaging the top tabbed bracket first,
then slide the lower L-bracket onto the positioning screws.
Each drawer panel can be adjusted
1
/4" (6) up and down
and side to side. Fasten all screws to the lower L-bracket
to secure the drawer panel.
The drawers can be placed back in the unit. Reconnect
the control cable for the top drawer. Refer to the illustra-
tion below.
Control cable.
BACK OF PANEL
TEMPLATE FLUSHWITH
TOP OF PANEL
SIDE
EDGE GAP
WILLVARY
Template position. Drawer panel installation.
TABBED BRACKET
L BRACKET