Filter
Top Products
Level the Unit
O
nce the unit is in position, extend the front leveling legs
down by turning the legs clockwise to adjust the height.
The rear height adjustment can be made from the front of
the base. Use a
3
/8" socket to adjust the rear rollers. Turn
the
3
/8" hex bolt clockwise to raise the unit or counter-
clockwise to lower it. Refer to the illustration below for
location of the rear roller base adjustment.
When the unit is properly leveled, door adjustments are
less likely to be necessary.
IMPORTANT NOTE: Be sure to reference leveling of the
unit to the floor and not surrounding cabinetry. This could
affect the operation of the unit, such as door closing.
To reduce the possibility of the unit tipping forward,
the front leveling legs must be in contact with the floor.
Model WS-30 Installation 40
Use an appliance dolly to move the unit near the rough
opening. Model WS-30 is equipped with rollers, so it can
be moved into position more easily. If possible, keep the
door closed until the unit is properly anchored.
IMPORTANT NOTE: If for any reason the unit has been
laid on its back or side, you must allow the unit to stand
upright for a minimum of 24 hours before connecting
power.
IMPORTANT NOTE: If used, side panels will need to be
installed before the unit is placed in its final position. Refer
to page 53.
The rear levelers must be in their lowest position in order
to roll the unit back into the rough opening. Leveling
cannot be completed until the unit is in position.
Shut off power to the electrical outlet. Plug the power cord
into the grounded outlet and roll the unit into position.
Make sure the anti-tip brackets are properly engaged.
Position the Unit
Before moving model WS-30 into position, secure the
door closed and protect any finished flooring.
FRONT
LEVELING LEG
REAR
ADJUSTMENT
Rear roller base adjustment.