Sub-Zero 427G Refrigerator User Manual


 
Anti-Tip Bracket Installation
MODEL 424FSG—WOOD FLOORS
Use the four #12 x 2
1
/2" wood screws and the four
1
/4"
flat washers provided. Drill pilot holes
3
/1
6
" (5) diameter
maximum, and be sure that the screws penetrate through
the flooring material and into the wall plate a minimum of
3
/4" (19). Be sure that the screws hold tight. Refer to the
illustration below.
MODEL 424FSG—CONCRETE FLOORS
Use the two
3
/8" x 3
3
/4" concrete wedge anchors, two
#12 x 2
1
/2" wood screws and two
1
/4" flat washers
provided. Be sure that the anchors and screws hold tight.
Refer to the illustration below.
IMPORTANT NOTE: In some installations the subflooring
or finished floor may require angling the wood screws
used to fasten the anti-tip bracket to the back wall.
Models 424G and 424FSG Installation 9
subzero.com
Make sure that there are no electrical wires in the area
which the screws could penetrate.
12
3
/16"
(310)
12
3
/16"
(310)
24"
(610)
C
L
FINISHED FLOORING
UNDERLAYMENT
WALL PLATE
SUBFLOORING
WOOD FLOOR
Wood floors. Concrete floors.
24"
(610)
C
L
1
1
/2"
min
(38)
12
3
/16"
(310)
12
3
/16"
(310)
FINISHED FLOORING
UNDERLAYMENT
WALL PLATE
SUBFLOORING
CONCRETE
FLOOR
INSTALL CONCRETE WEDGE ANCHORS:
1) Drill a
3
/8" (10) diameter hole any depth exceeding the
minimum embedment. Clean the hole or continue
drilling additional depth to accommodate drill fines.
Use a carbide drill bit manufactured within ANSI
B94.12-77.
2) Assemble the washer and nut flush with the end of
anchor to protect threads. Drive the anchor through the
material to be fastened until the washer is flush with
the surface material.
3) Expand the anchor by tightening the nut 3–5 turns past
hand-tight position or to 25 foot-pounds of torque.
Always wear safety glasses and use other necessary
protective devices or apparel when installing or
working with anchors.
Anchors are not recommended for use in lightweight
masonry material such as block or brick, or for use in
new concrete which has not had sufficient time to cure.
The use of core drills is not recommended to drill holes
for the anchors.