Sub-Zero 427G Refrigerator User Manual


 
Home Alarm Connections
I
f a home alarm system is to be installed on the wine
storage unit, the connections should be made according
to the alarm specifications. Refer to the illustration for the
appliance lead locations, and refer to the following for
color codes:
Normally open contacts – white with red stripe wire.
Normally closed contacts white with blue stripe wire.
Common – gray with white stripe wire.
Use the
1
/4" spade terminals or wire nuts provided to
make the proper wiring connections.
IMPORTANT NOTE: If you are not responsible for alarm
system connection, this information should be supplied to
the home security system contractor.
Model WS-30 Installation 43
subzero.com
The alarm circuit in the unit is intended as a low-
voltage, low-current device only. It should not be used
to switch line power.
Any unused terminals should be completely insulated
and all wires should be secured away from conductive
or moving components.
HOME ALARM
CONNECTIONS
Home alarm connections.
Complete the Installation
INSTALL KICKPLATE
Make sure the drain pan is in the proper position before
installing the kickplate. To install, screw the kickplate to
brackets attached to the inside surface of each roller
base. Refer to the illustration below.
IMPORTANT NOTE: The kickplate must be removable for
service. The floor cannot interfere with removal.
Reinstall the grille following the instructions on page 39.
Turn power back on to the electrical outlet.
OPTIONAL 90° DOOR STOP
The door of the model WS-30 opens to 110°. A 90° door
stop is provided with the unit (located behind the grille) for
installations where the door opening must be limited.
Additional 90° door stop kits are available through your
authorized Sub-Zero dealer.
The 90° door stop will be installed in the top hinge. To
install, open the door to approximately 90°. At the top of
the door, insert the door stop between the door hinge and
the door closer arm. Insert the screw through the door
stop and into the door as shown in the illustration below.
Kickplate installation. 90° door stop.