Filter
Top Products
Models 427 and 427R Installation 19
subzero.com
Electrical Requirements
HOME ALARM SYSTEM
If a home alarm system is to be used, refer to wiring
connections on page 24. In addition to operating power,
the installer may also be required to supply a home
automation system lead to the unit. This is for a low-
voltage, low-current signal similar to door and window
sensor signals. Common, normally open and normally
closed contact configurations are provided.
Three
1
/4" (6) female spade connectors are located in the
compressor compartment and are accessible behind the
kickplate/grille on models 427 and 427R. A minimum of
36" (914) of lead wire should be provided for each contact,
exiting the back wall near the electrical outlet.
Before moving the wine storage unit into position,
protect any finished flooring with appropriate
materials.
Unpacking and Moving
U
ncrate the unit, remove its wood base and discard the
shipping bolts that hold the wood base to the bottom of
the unit. Remove all packing materials and tape.
IMPORTANT NOTE: Do not discard the kickplate/grille,
anti-tip bracket and hardware. These items will be needed
for the installation.
All roller-assembly wine shelves should be removed to
reduce weight and prevent them from rolling. To remove,
pull the shelf out to its full extension, gently and evenly lift
up on both sides of the front of the shelf and remove.
Reverse the procedure to reinstall the shelf.
Retract the front leveling legs to allow you to move the
unit more easily during installation. You will extend the
leveling legs when the unit is in its final position to reduce
the possibility of the unit tipping forward.
Use an appliance dolly to move the wine storage unit.
Position the dolly at the side of the unit to prevent damage
to finished surfaces.