Filter
Top Products
14
Operating Procedures
Models 382/RC25
Place the draw valve spring over the shaft end on the
draw valve.
Figure 13
Insert the draw valve and spring into the door spout
until the threaded end of the shaft passes through the
hole in the end of the door spout. Thread the draw
valve knob onto the end of the draw valve shaft.
Figure 14
Place the door spout seal o-ring into the g roove in the
door and lubricate the components.
Figure 15
Align the draw spout assembly with the door. Place the
draw spout mounting plate over the draw spout
assembly and align the holes.
Figure 16
Using the thumb screws, fasten the draw spout
assembly and draw spout mounting plate to the door.
Figure 17
Slide the o-ring into the groove on the prime plug.
Apply an even coat of lubricant to the o-ring and shaft.
Figure 18
Install the prime plug into the bleed port in the top of the
freezer door. Do not over-tighten the prime plug.