Filter
Top Products
19
Models 382/RC25 Operating Procedures
Step 3
Place the control switch in the “WASH” position. With
a mix pail beneath the door spout, open the draw valve.
Drain all t he rinse water from the freezing cylinder .
When the rinse water stops f lowing from the door
spout, close the draw valve and place the control
switch in the “OFF” position.
Figure 35
Repeat this procedure until the rinse water being
drawn from the freezing cylinder is clear.
Cleaning
Step 1
Prepare two gallons (7.6 liters) of an approved
cleaning solution (Example: Kay-5t). USE WARM
W ATER AND FOLLOW THE MANUF ACTURER’S
SPECIFICATIONS.
Step 2
Pour the cleaning solution into the hopper and allow it
to flow into the freezing cylinder.
Figure 36
Step 3
Brush clean the mix hopper, the mix inlet hole, and the
mix level sensing probes.
Step 4
Place the control switch in the “W ASH” position. This
will cause the cleaning solution in the freezing cylinder
to be agitated. Allow the s olution to agitate f or five
minutes.
Figure 37
Step 5
Place the control switch in the “OFF” position. Place an
empty mix pail beneath the door spout. Open the draw
valve and draw off all of the cleaning solution. When
the solution stops flowing from the door spout, close
the draw valve.
Figure 38