Filter
Top Products
13 - ENGLISH
6. MAINTENANCE
6.1 ROUTINE MAINTENANCE (ADDRESSED TO THE USER)
During production, cleaning and maintenance operations, never touch the machine with
hands or tools without making sure that the machine has been disconnected from mains.
In case of troubles, make sure that they are not caused by a lack of servicing. On the
contrary, ask for the intervention of a TAYLOR COMPANY customer service. In case it is
necessary to replace a piece, always ask a distributor or an authorized retailer for
ORIGINAL spare parts.
It is advisable to make the machine be checked by a Customer Service every 6/8 months.
6.1.1 CLEANING AND SANITIZATION
Bacteria and moulds easily proliferate due to the presence of fats in cream, that is why it is
necessary to carefully wash and clean all parts in contact with the product, such as the
cylinder, the agitator and the door.
Rustless materials and/or made of plastic for food
industry used for our machines, in conformity with the
most severe international standards, make washing
operations easier, however they cannot prevent mould
proliferation, etc. caused by insufficient cleaning.
TAYLOR COMPANY recommends cleaning the tank
and the parts in contact with the product after the
employment and in any case in compliance with the
sanitary standards in force in the country of
installation. To thoroughly clean your batch freezer,
proceed as follows:
1. Pour 4.2 quart (4 litres) of clean cold water into the
cylinder.
2. Press the DELIVERY pushbutton and make the
machine run for a few minutes. Press STOP and
run off the washing water. Repeat the operation
until the water coming out of the cylinder is clean.
3. Pour 4.2 quart (4 litres) of detergent
solution/sanitizer into the cylinder.
4. Press the DELIVERY pushbutton and make the
machine run for a few minutes. Then press STOP
and run off the detergent solution.
5. Dismantle the door. To do this, turn the lever
upwards, make the door rotate towards the left and
holding it with a hand, remove the hinged knob
with the other hand. At this point the door can be
disassembled.