Filter
Top Products
22
Model C712Operating Procedures
Step 6
Before installing the beater assembly, check the
scraper blades for any nicks or signs of wear. If any
nicks are present, or if the blades are worn, replace
both blades.
If the blades are in good condition, install the
scraper blade clips over the scraper blades. Place
the rear scraper blade over the rear holding pin on
the beater. (See Figure 33.)
Figure 33
Note: Scraper blades should be replaced every 3
months.
Note: The hole on the scraper blade must fit
securely over the pin to prevent costly damage.
Step 7
Holding the rear blade on the beater, slide it into the
freezing cylinder halfway. Install the front scraper
blade over the front holding pin. (See Figure 34.)
Figure 34
Step 8
Install the beater shoes. (See Figure 35.)
Figure 35
Step 9
Slide the beater assembly the rest of the way into
the freezing cylinder.
Make sure the beater assembly is in position over
the drive shaft by turning the beater slightly until the
beater is properly seated. When in position, the
beater will not protrude beyond the front of the
freezing cylinder. (See Figure 36.)
Figure 36
Repeat these steps for the other side of the
machine.