13
Models RD30/RC25 Operating Procedures
Insert the torque rotor (guide bearing endfirst) into the
pilot holein thecenter ofthe drive shaft. Thehole in the
torque rotor shaft should be rotated to the 12 o’clock
position.
Figure 10
Step 4
Install the freezer door. Slide the draw valve o- r ing
into the groove on the draw valve and lubricate the
o- r ing.
Figure 11
Place the draw valve spring over the shaft end on the
draw valve.
Figure 12
Insert the draw v alve and s pring into the door spout
until the threaded end of the shaft passes through the
hole in the end of the door spout. Thread the draw
valve knob onto the end of the draw valve shaft.
Figure 13