Thermador HS-HST-HSB Ventilation Hood User Manual


 
Page 12
Wall Mount Installation -
HST series Hood only
(see Figure 6-7-8)
1. Hood Installation Height
After the hood installation height
has been determined draw a
horizontal line at a distance
above the cooktop equal to the
desired hood installation height
plus 16 1/2. This line is the
mounting location of the wooden
bracket shipped with the hood.
2. Find the centerline of the
cooktop. Draw a vertical line
along this centerline up to the
horizontal line drawn in step 1.
3. The HST series hoods are
mounted to the wall using a
wooden bracket shipped with
the hood. Remove the bracket
from the hood by removing two
shipping screws. Mark the
centerline of the bracket.
4. Find studs behind the drywall
by tapping the wall or using a
stud finder. Locate one stud on
either side of the cooktop
centerline to use for mounting
the wooden bracket as shown
in Figure 6.
5. Align the top of the wood bracket
along the horizontal line drawn
in step 1. Align the centerlines
of the bracket and cooktop.
6. Drill a 3 deep 1/8 tap hole
through the wooden bracket,
drywall, and into the stud.
7. Use 2-4 (6mm x 80 mm) screws
to attach the bracket to the wall
as shown in Figure 7. For
support of longer hoods, use
Figure 6
Figure 7
6 7/8
6