Thermador HS-HST-HSB Ventilation Hood User Manual


 
Page 9
TYPICAL INSTALLATION
The hoods are designed for either
vertical or horizontal discharge as
shown in Figure A and B
respectively.
The height from the countertop
to the bottom of the hood is 30" to
36”.These hoods are not
recommended to be used over
indoor grills.
DUCTING
Provide a Round Duct having a
diameter of 8 (see Figure A and B
for location and Figure 1 for location
on wall or cabinet bottom).
Install a 1/2 conduit from the
service panel long enough to reach
the hood once it is installed.
Power supply must be rated for 120V
60Hz, 15 amps (minimum).
Note - Horizontal Discharge:
The Transition for this discharge
direction is not supplied and
must be purchased separately.
BEFORE INSTALLING HOOD