Thermador SEM302 Convection Oven User Manual


 
12
SEM/SEMW Oven Care and Use Manual
Setting the Timer
To Change a Timer:
1. Touch TIMER 1 or TIMER 2.
2. Enter the new desired time.
3. Touch the START pad.
To Set Both TIMER 1 and TIMER 2:
Follow the steps above to set each Timer. The Timer with the least amount of countdown time has
display priority. The countdown display for the second timer is shown automatically when the first
timer has ended.
The words “TIMER 1” and “TIMER 2” are both displayed along with the number countdown.
The designation, “TIMER 1” or “TIMER 2” with the least remaining countdown time is more brightly
lit than the other.
During the countdown, touch CLOCK or TIMER. Depending on the pad touched, either the time of
day or the remaining time is briefly displayed.
The oven has two Timers, which are independent of each other.
Neither timer controls oven operations.
Touch once and the Timer is set in minutes and seconds.
Touch twice and the Timer is set in hours and minutes.
To Cancel an Active Timer:
Select TIMER 1 OFF or TIMER 2 OFF.
1. Select TIMER 1 or TIMER 2.
Message scrolls in display.
MIN SEC
––
:
––
You Will See
To set TIMER 1 or TIMER 2:
Oven Operations
Touch
START
Touch
TIMER OFF
Touch
TIMER 1
Touch
3 0 0
End
MIN SEC
TIMER 1
3:00
MIN SEC
TIMER 1
3:00
Touch TIMER 1 again for hrs and Min then
select length of time then touch start
Note: If timer is not turned off, beeps
will continue every 30 seconds. After
5 minutes, beeps stop and the display
reverts to the previous time of day.
TIMER 1
TIMER 1
2 . Set the amount of time.
(Example shows a 3-minute
setting with Timer 1.)
3 . Start Timer.
4 . When set time is complete,
“End” is displayed and 2 long beeps
signal. When turned off, display
reverts to time of day.